tfaour
a3ab6c5f13
Build and push server image / build-and-push (push) Successful in 36s
- version.txt + esp_app_desc_t version reporting (X-Frame-Version header); new ota_update.c checks the server's advertised version against the running one and streams+applies an update via esp_https_ota, gated by bootloader rollback (marks the image valid only after a full successful cycle, so a bad update can't brick a wall-mounted frame). - Dual-OTA partition tables: partitions.csv (8MB dev board, 2MB slots) and new partitions_xiao.csv (4MB XIAO, 1.875MB slots -- the dev board's table doesn't fit the XIAO's flash). New build_for_board.sh gives each board its own build dir + generated sdkconfig via SDKCONFIG_DEFAULTS layering, so switching boards never clobbers the other's config. - fetch_photo_info()/fetch_face_labels() were using the short reachability-check timeout even though the manage-menu path can be the first (cold, TLS-handshake-paying) request of a wake cycle -- switched to the longer fetch timeout to stop spurious ESP_ERR_HTTP_CONNECT failures. - XIAO: the RF switch that selects onboard vs. external antenna (GPIO3/14) isn't initialized by plain ESP-IDF the way Seeed's Arduino package does it, leaving WiFi unable to reliably reach the antenna at all -- new board_antenna.c powers the switch and selects the onboard antenna, gated behind FRAME_XIAO_ANTENNA_INIT (on by default in sdkconfig.xiao). Also remaps the EPD DC/RST/BUSY pins, since the dev board's defaults (GPIO9/10/11) aren't physically exposed on the XIAO.
35 lines
1018 B
C
35 lines
1018 B
C
#include "board_antenna.h"
|
|
|
|
#if CONFIG_FRAME_XIAO_ANTENNA_INIT
|
|
|
|
#include "driver/gpio.h"
|
|
|
|
// Fixed by the XIAO ESP32-C6's own PCB (the RF switch wiring, not
|
|
// user-configurable), not exposed as Kconfig pins the way the EPD/button
|
|
// GPIOs are. GPIO3 is the switch's power enable (active low), GPIO14
|
|
// selects onboard (low) vs external u.FL (high) antenna. Seeed's own
|
|
// Arduino board package does this at boot automatically; plain ESP-IDF
|
|
// does not, so without it the switch is left unpowered/floating and the
|
|
// radio doesn't reliably reach the onboard antenna.
|
|
#define ANTENNA_SWITCH_POWER_GPIO 3
|
|
#define ANTENNA_SELECT_GPIO 14
|
|
|
|
void board_antenna_select_onboard(void)
|
|
{
|
|
gpio_config_t cfg = {
|
|
.pin_bit_mask = (1ULL << ANTENNA_SWITCH_POWER_GPIO) | (1ULL << ANTENNA_SELECT_GPIO),
|
|
.mode = GPIO_MODE_OUTPUT,
|
|
};
|
|
gpio_config(&cfg);
|
|
gpio_set_level(ANTENNA_SWITCH_POWER_GPIO, 0);
|
|
gpio_set_level(ANTENNA_SELECT_GPIO, 0);
|
|
}
|
|
|
|
#else
|
|
|
|
void board_antenna_select_onboard(void)
|
|
{
|
|
}
|
|
|
|
#endif
|